need some advice on a auto to manual conversion
#11
Registered Member
Thread Starter
Join Date: Nov 2008
Posts: 1,672
Likes: 0
Received 0 Likes
on
0 Posts
Re: need some advice on a auto to manual conversion
when i turn key the car jumps like it is stuck in gear.. i do not know why but i do know ive properly installed everything correct..
#12
Re: need some advice on a auto to manual conversion
and did you make sure that the realease bearing and fork were installed properly? this could also cause the issue.
#13
SPARKLEmotion
Join Date: Feb 2007
Location: Harlem Springs
Posts: 3,084
Likes: 0
Received 0 Likes
on
0 Posts
Re: need some advice on a auto to manual conversion
The car starts without the clutch, and when it is running the shift linkage acts like it will not go into gear while the car is on with th eclutch engaged. when the car is off it goes in fine??? im so lost as to what to do and im pulling my hair out over this damn car. any help is thankful and appreciated!
#14
Re: need some advice on a auto to manual conversion
Throw-out bearing? Everything installed correctly?
My 300zx did this for like 3 clutch installs until Brady at CCC discovered people kept putting this little 50 cent clip on the wrong way. It would do the same thing, get stuck in gear and wouldn't disengage and jump/lurch when I tried to start it, etc.
My 300zx did this for like 3 clutch installs until Brady at CCC discovered people kept putting this little 50 cent clip on the wrong way. It would do the same thing, get stuck in gear and wouldn't disengage and jump/lurch when I tried to start it, etc.
#15
Registered Member
Thread Starter
Join Date: Nov 2008
Posts: 1,672
Likes: 0
Received 0 Likes
on
0 Posts
Re: need some advice on a auto to manual conversion
yes i used the alignment tool on the clutch, if that is the problem it sucks but its not too bad or hard of a job to handle putting a new clutch in. i bought a clutch out of a gsr with a stock pressure plate and flywheel is stock as well. I guess ima try to bleed the clutch one more time and see since i installed the new master and slave cylinders that it may not have enough fluids or somehtign.. that would be awsome but not likely.
on a side note. u guys are bright individuals thanks for the insight
on a side note. u guys are bright individuals thanks for the insight
Thread
Thread Starter
Forum
Replies
Last Post