civic mtr question please help
#1
civic mtr question please help
I got a 95 civic ex with a 1.6 vtec (d16z6) the head bolt holes n the block was stripped out so i took the block and had it drilled for 1/2 inch head bolts but im blowing head gaskets like crazy. The head has been decked .020 should i use shorter head bolts so it pulls the head tighter to the block?
#2
baller/dickbutt#69
Join Date: Nov 2002
Location: hampton
Posts: 16,059
Likes: 0
Received 0 Likes
on
0 Posts
Re: civic mtr question please help
I got a 95 civic ex with a 1.6 vtec (d16z6) the head bolt holes n the block was stripped out so i took the block and had it drilled for 1/2 inch head bolts but im blowing head gaskets like crazy. The head has been decked .020 should i use shorter head bolts so it pulls the head tighter to the block?
#3
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: civic mtr question please help
0.020" off the head won't cause problems with bolt length. Nothing should be close enough in length or depth to make it sensitive like that, unless there is some problem with the new head bolts or how the new holes were drilled and tapped. Actually, any problem related to the new bolts or new holes would likely be a problem whether the head was decked or not. Unless of course the head was decked improperly (not flat, etc), among other things.
Have you changed your torque spec because of the larger bolts?
Have you changed your torque spec because of the larger bolts?
Thread
Thread Starter
Forum
Replies
Last Post