Automatic Transmission Failure after rebuild
#11
Registered Member
Join Date: Jul 2004
Location: H-Town
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
Re: Automatic Transmission Failure after rebuild
I rebuilt the 4R100 in my truck when it wouldn't shift into 3rd. I was puzzled as I was putting it back togethter afer rebuilding it with a full mud bog kit because everything replaced was in good condition. After some investigation I noticed the 2 to 3 gear shiflt valve was stuck open in the valve body. 2 new seals and de-burr the cylinder were that were need, could have been done with the trans in the truck. Sometimes it is the simple stuff... I reccomend taking a close look at the valve bodies for the original problem after you fix the pump.
#12
Doing work mofo
Thread Starter
Join Date: Jun 2007
Location: Richmond
Posts: 2,287
Likes: 0
Received 0 Likes
on
0 Posts
Re: Automatic Transmission Failure after rebuild
I even took another valve body off a working 4l60e and put it on the truck and still had the same issue of no 3rd. Even put another 3-4 housing in and still didnt change anything.
I couldnt figure out what I was doing wrong .
I couldnt figure out what I was doing wrong .
Thread
Thread Starter
Forum
Replies
Last Post