once again check to make sure all your wires are hooked up by checking the sensor output screen, it will display voltages if theyre hooked up, with those size injectors your correction should be set at about -45 to -50.....

 

the sensors all have voltage. I had the correction set to -38 the first day and she ran fine... ive tried -45 and -50 as well

 

are you sure all the injectors are working?

 

same thing happend to me, all it turned out to be was a bad fuel pressure regulator. i hope your problem is a simple as mine turned out to be. good luck man

 

I had the same problem when I was running the hack on my )) SI. It turns out that two of the injectors were not working. So no matter how much I changed the settings it still ran like shit. Got new injectors and everything worked perfectly. As for the manual if you go to APEXI website they have it in english so you can download it. I hope this helps.

 

im beginning to think it may be a bad injector...

 

you can put your stock ones in, and dial them in at 0% change. and see if it idle's. did you get them used?

 

i cant put the stock ones back in... tried it already. since the bottom seals are larger, they spray fuel everywhere

 

ouch, I installed my safc with my stock injectors first to make sure everything was running right....but yea sounds like a bad injector(s)

 

yeah, i did the same thing, i installed it with my stock injectors first. well, i would ask one of your friends for some injectors to test it out.