Now all I have to do is wait for the mailman... I hate that.

http://www.youtube.com/watch?v=1qSPP95zdCQ&feature=g-all-u

 

I changed my oil today, almost freaked when i saw sparkles in the oil then I realized the drain pan i used was sitting in my metal working corner and I had been flinging grinding material in that area for weeks.

Without realizing that fact I would have freaked but I had gotten to the point where... it might as well happen, my luck with engines is this shitty already.

 

I'm still having a hard time seeing exactly why he laid it down...

 

lol, glad to see everything is okay though.

My oil looked like mother-of-pearl at the 600 mile service.

 

Dude, I literally hit the 6 key like 30 times trying to figure it out.

 

that's a good thing for 2 reasons: 1 you have a magnetic drain plug (amirite) so that means all the metal is aluminum (probably crank bearings) otherwise it would be on the magnet. and 2 your crank bearings are now properly broken in and so are your piston rings hopefully so you can dawg the shit out of it now.

 

So I take it you don't believe in this?

http://www.mototuneusa.com/break_in_secrets.htm

 

Bad body position and he washed the front end. You can see the front wheel slip about 0:08. Hard to tell because of the shadow.

 

That plus he was afraid to put the necessary throttle on at the end of that turn.. It's a known slick spot.

Oil apparently.

 

Oh well. Not about if you'll go down, but when.

Vid says road was clean, 60 degree temp.