How to Make A Skunk2 Pro Series+ Camber Kit (Pictures)
#11
Registered Member
Thread Starter
Join Date: May 2008
Location: Hampton, VA
Posts: 1,210
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to Make A Skunk2 Pro Series+ Camber Kit (Pictures)
it is cheaper to buy everything and build this one. im sure the polyurethane bushings in this would be as good, probably better than the ones in the skunk2 pro series plus arms. price list edited. i already had the upper control arm poly bushings from my front end kit so that was free, and i was fixing a shot camber kit so that was basically free because i already had it. so this cost me basically the price of two skunk2 ball joints, 34.05 x2 = 68.10 plus whatever s/h was. so for me, this worked well.
Last edited by disheeki546; 07-23-2009 at 12:56 PM.
#12
Registered Member
Thread Starter
Join Date: May 2008
Location: Hampton, VA
Posts: 1,210
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to Make A Skunk2 Pro Series+ Camber Kit (Pictures)
ttt
#14
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to Make A Skunk2 Pro Series+ Camber Kit (Pictures)
So you're saving money by buying a poor quality control arm with poor quality bushings and poor quality ball joint, then swapping out for a good quality ball joint and bushings. So you're now left with a poor quality control arm.
I think this is a somewhat backward approach...
It sounds like ( $50 + 35 ) x 2, so $170 in replacement parts, so you're not far off buying the Skunk2 part in the first place...? So you save $60 that should arguably be spent toward a better quality set of control arms?
I think this is a somewhat backward approach...
It sounds like ( $50 + 35 ) x 2, so $170 in replacement parts, so you're not far off buying the Skunk2 part in the first place...? So you save $60 that should arguably be spent toward a better quality set of control arms?
Last edited by Fabrik8; 07-10-2014 at 09:58 AM.
#15
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: How to Make A Skunk2 Pro Series+ Camber Kit (Pictures)
And holy shit, why are you bumping a thread from 2009?
Thread
Thread Starter
Forum
Replies
Last Post
elambz
Suspension / Brakes
1
05-24-2009 08:40 AM