Cycle whore thread
Re: Cycle whore thread
If i had to guess ide say he took the track van....but thats just a guess.
Buddy of mine did a run up the drafon with a pack of Groms not to long ago. I been beating around the bush saying ill get there but ive done taken my bike off the road till it sells.
Buddy of mine did a run up the drafon with a pack of Groms not to long ago. I been beating around the bush saying ill get there but ive done taken my bike off the road till it sells.
Re: Cycle whore thread
Loaded in the van with a buddy's bike. Was an AWESOME time. Some guy fell of the side and died while I was riding it. They didn't find him for over 24 hours later. Stopped by wheels in time museum on the way home. Super cool place. Then broke down 1.5 hours from home lol
Re: Cycle whore thread
I just refurbished a tilt load trailer for bike use, i THINK i can put more than one bike on at a time. I just haven't had any motivation to go fix the wiring on my bike. It has literally sat untouched since the connection burnt up back in early October.
Re: Cycle whore thread
It has no rear brake at all, by the time i sourced and shipped a master, line and caliper the likeliness of it getting here in time is slim to shit.
I also need to find the proper rectifier, apparently my sp-2 has an sp-1 part in it`s place which keeps cooking my soldered connections. It`s burnt up my repairs twice now an is getting sorta close to the wiring harness itself leaving me not much to work with for another repair. And for some fucking reason the wiring at the harness side is a thicker gauge than on the rectifier side of the plug so the difference in size of wire is creating an issue with my connection creating to much heat and melting itself. First time around it melted the plug entirely so i took that out all together...........it`s a pain in the dick.
Wish someone would take this fucker off my hands.
Edit, went ahead and ordered all of the parts mentioned above lol
I also need to find the proper rectifier, apparently my sp-2 has an sp-1 part in it`s place which keeps cooking my soldered connections. It`s burnt up my repairs twice now an is getting sorta close to the wiring harness itself leaving me not much to work with for another repair. And for some fucking reason the wiring at the harness side is a thicker gauge than on the rectifier side of the plug so the difference in size of wire is creating an issue with my connection creating to much heat and melting itself. First time around it melted the plug entirely so i took that out all together...........it`s a pain in the dick.
Wish someone would take this fucker off my hands.
Edit, went ahead and ordered all of the parts mentioned above lol
Last edited by Hooch; 11-05-2016 at 03:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post