Post pics of your rides
Derp Status
Joined: Jul 2009
Posts: 1,305
Likes: 0
From: Alexandria
Derp Status
Joined: Jul 2009
Posts: 1,305
Likes: 0
From: Alexandria
Re: Post pics of your rides
New to the forum from Rockville
POS for sale $4.00 USD
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3534.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/TERCEL003-3.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3536.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3540.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3546.jpg[IMG]
Daily
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3617.jpg[IMG]
POS for sale $4.00 USD
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3534.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/TERCEL003-3.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3536.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3540.jpg[IMG]
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3546.jpg[IMG]
Daily
[IMG]http://i157.photobucket.com/albums/t80/stlyj/IMGP3617.jpg[IMG]
Thread Starter
Bath salt trippin'
Joined: May 2004
Posts: 9,240
Likes: 0
From: Nova
Re: Post pics of your rides
Hey faggots.
Last time I'm saying it before I hand out infractions: I don't care if you wanna be dumb/unoriginal/unfunny trolls and want to leghump a chick, just make another thread for it, and not derail one that's already established.
Last time I'm saying it before I hand out infractions: I don't care if you wanna be dumb/unoriginal/unfunny trolls and want to leghump a chick, just make another thread for it, and not derail one that's already established.
Capt. Spaulding
Joined: Oct 2004
Posts: 1,058
Likes: 0
From: arlington va
Registered Member
Joined: Jan 2010
Posts: 910
Likes: 0
From: Fredericksburg
Re: Post pics of your rides
Specs:
1992 Plymouth Laser RS (AWD)
MOTAR:
6 bolt motor been built by Slowboy Racing (previous owner, I would never go with SBR).
Manley pistons (8.5:1 compression)
Manley rods
Reenforced girdle support
All fastened with ARP hardware.
7000 miles on new motor.
Ready for (claimed) 800 AWHP.
Head:
Fresh rebuild
Not sure of springs/valves, I assume stock.
Kelford 272 Cams
Air path:
IN:
K&N Filter
Custom Hard intake pipe
EVO III 16g
SBR FMIC kit
TiAL 50mm BOV
OUT:
SBR Cast exhaust manifold
Ported turbine
Custom 3” O2 sensor housing
VRS 3” Exhaust all the way out.
Go Juice:
Walboro 255 Fuel pump
1050cc injectors
DSMLink V3
Suspension:
Eibach Sportline Springs
Stock Struts (booo!)
17” Drag DR-33 wheels (black with red stripe lip).
Nitto Neo Gen Tires
Powerslot Rotors on all 4.
Hawk HPS pads.
Inside:
AEM TruBoost gauge/controller
AEM UEGO Wideband A/F gauge
Corbeau seats
Momo 12” Steering wheel.
Drivetrain:
ACT2600 Pressure Plate
ACT Organic Clutch Disc
Fidanza Light-weight Flywheel.
Last dyno sheet was 351 AWHP on the 550cc injectors, the previous owner had 1050cc injectors and retuned he claimed over 400 AWHP, I never say a dyno sheet. But the boost is set at 18 psi with a A/F of 10.5:1 which is a pretty conservative tune. So I dunno. I have someone willing to build me a custom WG actuator using a Holset actuator on a Mitsubishi actuator bracket, to keep the wastegate shut at higher boost levels. Then turn the boost up to 24 psi and retun for 11.5:1
More pics
1992 Plymouth Laser RS (AWD)
MOTAR:
6 bolt motor been built by Slowboy Racing (previous owner, I would never go with SBR).
Manley pistons (8.5:1 compression)
Manley rods
Reenforced girdle support
All fastened with ARP hardware.
7000 miles on new motor.
Ready for (claimed) 800 AWHP.
Head:
Fresh rebuild
Not sure of springs/valves, I assume stock.
Kelford 272 Cams
Air path:
IN:
K&N Filter
Custom Hard intake pipe
EVO III 16g
SBR FMIC kit
TiAL 50mm BOV
OUT:
SBR Cast exhaust manifold
Ported turbine
Custom 3” O2 sensor housing
VRS 3” Exhaust all the way out.
Go Juice:
Walboro 255 Fuel pump
1050cc injectors
DSMLink V3
Suspension:
Eibach Sportline Springs
Stock Struts (booo!)
17” Drag DR-33 wheels (black with red stripe lip).
Nitto Neo Gen Tires
Powerslot Rotors on all 4.
Hawk HPS pads.
Inside:
AEM TruBoost gauge/controller
AEM UEGO Wideband A/F gauge
Corbeau seats
Momo 12” Steering wheel.
Drivetrain:
ACT2600 Pressure Plate
ACT Organic Clutch Disc
Fidanza Light-weight Flywheel.
Last dyno sheet was 351 AWHP on the 550cc injectors, the previous owner had 1050cc injectors and retuned he claimed over 400 AWHP, I never say a dyno sheet. But the boost is set at 18 psi with a A/F of 10.5:1 which is a pretty conservative tune. So I dunno. I have someone willing to build me a custom WG actuator using a Holset actuator on a Mitsubishi actuator bracket, to keep the wastegate shut at higher boost levels. Then turn the boost up to 24 psi and retun for 11.5:1
More pics
Last edited by laserspeeddemon; Sep 22, 2010 at 11:55 AM.
