300zx brake problems
04-19-2009 | 06:46 PM
#11
Registered Member
Joined: Dec 2003
Posts: 1,026
Likes: 0
From: Virginia Beach
Re: 300zx brake problems
very true, that's why i said unless there is a difference in the hollow spot between two halfs of the disc. if it is the same on both rotors then that means only thing different on thicker rotors is the thickness of the walls . therefore IF its only thing different, cutting it below min thickness is ok because all it will do is bring the rotor specs down to that of a thinner 26mm
follow my logic?
follow my logic?
04-19-2009 | 06:58 PM
#13
Thread Starter
GUIBO!?
Joined: May 2004
Posts: 5,999
Likes: 0
From: Virginia Beach
Re: 300zx brake problems
^I was just making sure what I did was right, minus the fact I didnt ensure what size caliper I had.
Yea I see what you mean.
very true, that's why i said unless there is a difference in the hollow spot between two halfs of the disc. if it is the same on both rotors then that means only thing different on thicker rotors is the thickness of the walls . therefore IF its only thing different, cutting it below min thickness is ok because all it will do is bring the rotor specs down to that of a thinner 26mm
follow my logic?
follow my logic?
Thread
Thread Starter
Forum
Replies
Last Post