93 Accord Coupe SE
#11
Registered Member
Join Date: May 2010
Location: Newport News
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
![marco has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
i have to quote you wrong on that i had a cb7 92 lx had it four years put the h22a1 in it a month after having it and used a 93 ex harness cause my lx one was full of oil
#13
Registered Member
Join Date: May 2010
Location: Newport News
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
![marco has disabled reputation](images/reputation/reputation_off.gif)
#14
Registered Member
Join Date: May 2009
Location: Franklin Co.
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
![kwh924 is an unknown quantity at this point](images/reputation/reputation_pos.gif)
![Default](images/icons/icon1.gif)
Exactly the 93 ex is not VTEC so if you want to use VTEC you need a VTEC ECU off of something else with and if you were using the 93 harness then I take it VTEC was hardwired straight from the ECU?
#15
![Default](images/icons/icon1.gif)
i have a 95 accord ex vtec 5 speed what would i have to do to put an h22 head on it and make it run again? Also need to know about how long it would take i know i can do all the work myself done ity to many bseries before. just dont know much about f and h series. all GOOD knowledge is appreciated!
#16
Registered Member
Join Date: May 2010
Location: Newport News
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
![marco has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
YEs my 92lx cb7 stock harrness wire up vtec use p28 chipped.... or p13 stock thats the way it will work properly..... hondata is great aem is the best but both cost a little extra money
#17
Registered Member
Join Date: May 2010
Location: Newport News
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
![marco has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
i have a 95 accord ex vtec 5 speed what would i have to do to put an h22 head on it and make it run again? Also need to know about how long it would take i know i can do all the work myself done ity to many bseries before. just dont know much about f and h series. all GOOD knowledge is appreciated!
Thread
Thread Starter
Forum
Replies
Last Post