where do you live

 

chesapeake

 

well i was going to say i know a really good guy in roanoke....the place is called norms transmissions.....he did also recommend me someone in williamsburg too but i can remember...i think i have his number in my car...if you call him and say you live in roanoke and explain over the phone he might be able to point you in the right direction....he will drive your car for free and tell you what he thinks too....but driving almost 300 miles is a bit much for good service

 

haha yeah. thats a good ways away when i can find someone close. i appreciate the offer and the input though. without a doubt.
im hoping sometime this weekend i can really have the time to look at everything so ANY ideas of what it could be is welcome just so i can check it all incase its more than one thing

 

Just add fluid... it's really impossible to check the fluid level anyway....

 

Good Luck!!

 

Sounds like a throwout bearing.

 

thanks man and thanks for all your advice. im going to look at it and do everything you said and everything else from everyone

i appreciate the advice from everyone

 

okay.
so i finally had a free second when it was light outside after work today to mess around. i found the clutch cable. theres a plastic nut that you can loosen or tighten. i tightened it down a good ways just hand tight and the clutch feels sotally different. the sensitivity and pop of a stage 2 clutch is there now and it shifts like butter no troubles and no crunchy clanky grind to reverse or when i try to downshift to third!
but that noise is still there when i push the clutch in...
should i even worry about that?

 

i know mine really noisy when i let it out in neutral......stock TOB are made to be quite some aftermarket ones are just made loud......like my step dad says if it aint broken dont fix it