Questions about making my own hydraulic hardlines for brakes.
#11
TheMuhFuggin♂
Thread Starter
Join Date: Nov 2007
Location: Bodymore Murdaland
Posts: 5,443
Likes: 0
Received 0 Likes
on
0 Posts
Re: Questions about making my own hydraulic hardlines for brakes.
The line was 3/16. I was able to get a 40" one with the right fittings for the drivers side but needed a 63" one with two different fittings for the pass side. Went with the armortech lines and they're super easy to bend. You can even bend them back and rebend with NO issue.
Ended up getting a 70" with one of the fittings I needed on both sides. Cut it to length. Put the other weird fitting on and flared the end myself. With a decent flare kit it was actually REALLY easy and it's holding pressure well. Never thought I'd say this but....
Thanks for all the help Driven!
Ended up getting a 70" with one of the fittings I needed on both sides. Cut it to length. Put the other weird fitting on and flared the end myself. With a decent flare kit it was actually REALLY easy and it's holding pressure well. Never thought I'd say this but....
Thanks for all the help Driven!
Thread
Thread Starter
Forum
Replies
Last Post
Royalty
Automotive Discussion
7
04-21-2006 10:59 AM