I haven't played with a single cam in a while but I think theres only 10 bolts. It should come right off.


Why are you replacing your bearing anyways?

 

i bought the z6 bottom end a while ago with a spun bearing and i didnt think i was going to need it till i took off my y7 head today and headgasket blew plus it was a raggidy d15bi bottom end

and ive taken off the bolts and i dont want to pry it and risk crackin the bottom end
i saw a few hex keys but not sure what they do and i dont have my camera here with me to show you

 

ok i got it off just tapped it a few times

now i started taking off the rod bearings and as stupid as this sounds what does a spun rod bearing look like

i counted them and i only counted 9 and i found these skinnier thing on one rod look like a bigger but flat c compared to a small thick c

 

The small things are thrust bearings. There should be 2.

 

o ok
man im having trouble getting the new bearing im not sure how hey go in and i dont want to mess them up by doing it wrong

know of any diagram of steb by step directions or anyone have time to ride by its ryte off chesapeake boulevard

 

If I didnt have a client coming over tonight Id come by cause Im right by wards corner but I cant make it tonight bro. Sorry.

 

its straight is there like a pin thats supposto go through the bearings and through the rods,ive seen holes and was just wondering

 

naw thats the oil passage.

 

ooooooo ok
damn you know a lot haha
now you just need to tell me how to get them in the proper way,like maybe put both in half and half?or put one all the way in and let the other just chill on top?

 

where are you at on ches blvd.?