1989 Civic DX Project
#23
Not-So-Fatty McFat
Re: 1989 Civic DX Project
Yeah. the main hoop and harness bar at a minimal. and don't get the cheap stuff. in the event of an accident, gotta protect your noggin
#25
Registered Member
Thread Starter
Join Date: Aug 2011
Location: Gloucester
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
All the research I did said that the DC ebrake cables would not work. They infact do work I just had to switch out the mounting brackets from the old cables with the DC ones.
#26
Registered Member
Thread Starter
Join Date: Aug 2011
Location: Gloucester
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1989 Civic DX Project
Finally got around to pulling the valve cover and plugs today to see wtf is going on with this thing. Inside of the head looks great, peep down #1 cylinder and look at the piston head, covered in oil. Thanks guy. Hope I fucking see you again.
#28
Re: 1989 Civic DX Project
That is some really deep scarring. How ddep is the ridge at the top of the cylinder where the piston is at the top of its rotation?
Skimmed through and didnt see anything mentioned about the engine. Is this the motor that came in the vehicle?
Skimmed through and didnt see anything mentioned about the engine. Is this the motor that came in the vehicle?
Last edited by Mirrorimg; 02-03-2013 at 01:54 PM.
#29
Registered Member
Thread Starter
Join Date: Aug 2011
Location: Gloucester
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1989 Civic DX Project
Yes it came in the car, was claimed to be rebuilt. Haven't measured it yet, don't care to at the moment. Putting together my other LS for now. This will probably be the block I send to GE to be sleeved. Until then, this:
Thread
Thread Starter
Forum
Replies
Last Post