from your shop place you would take tidewater drive down to bay view then bay view to chesapeake boulevard then chesapeake boulevard to beach view and then ryte on pine view

 

PM me the addy and Ill try to get by there really quick

 

thanks alot jason for all the support and know how also with the part identifications and thanks for coming by when it was out of your way i really appreciate it and i will support bap geon and buy everything i need from there

 

they should just press in. nothing major. a spun bearing should look like a half circle metal peice that looks haggard as shit. Picture your new bearing, worn the fuck out. If its real bad it might be in small junks in your oil pan.


I'm not positive but if you spun a bearing you need to check ALL of your specs in the lower end because with the rod smacking around down there it can throw off a lot of shit. Basically your crank and everything could be all discombobulated. The small shreads of metal from the spun bearing could get in your oil, oil pickup, and even in/around other bearings.

Just give everything a VERY CLOSE look over and make sure nothing is loose or fucked upish.

Good luck, hopefully you just got a baby spun bearing with no other damage.

 

well there were small shavings around and i looked at it a bit and everything looked fine,i plan rebuilding the whole thing anyways but nothing top dollar

but thanks to you to for helping me and telling me what motor and year etc etc