yep thats what I picked up. I lost out on the auction for a cylinder and never see any .010 kits for decent prices. It should be here in the next week or so depending on ship times. What kind of turn around can I expect? My only worry is that I have to take off on the 13th and will be leaving my truck at the airport and my housesitter has a car and can't pick it up. Also going to need the fork seals done but I already have those.

 

If you refinish the furniture so I don't have to, then I can fix my bike and go riding!!!

And no prob.

 

as soon as you have all the parts, i can get it done that day, or the next, or the next.... whenever... just let me know when you've got all the parts, my schedule is pretty open.

 

i can get the cylinder bored same day.
if it comes down to it, and you have to leave, and have to leave the bike at my place, that's fine. it'll stay locked up in the back.

 

lol.....oh ok, makes sense now.

 

And when ya gonna fix that oil seal so's I can get it back in the frame? BTW where can I get new spokes for a 21" to a sporty hub?

 

buchannon spokes

and i'll put that oil seal in as soon as you have a place to do it. i'm trying not to crack motors open at my house if i can avoid it.

btw, i heard you wanted a couple hundred bucks for that front wheel. are ya nuts? you can buy new ultima 21's for $100 shipped.

 

It's not just the wheel.

Carry your ass over to my house and do it then.

 

bump for great service.

 

thanks man, much appreciated. lemme know if you need anything done in the future.

i've been BUSY today, sweating my butt off, and the day's not over yet. it's all good though, i'd rather have alot of work than not enough.

shane- got your motor out, haven't torn it down yet, but i will by the end of the day

the dude with the yzf600 (forgot yur name)- fixed your cooling problem. you were low on coolant, but there's no leaks. i flushed out all the old coolant, b/c it was nasty looking, and refilled it with fresh stuff. just have to do the oil change and some adjusting to the shifter, and you're good to go.

bustadust- well, abviosly your good to go now, and now you know how to adjust your clutch. STOP DOING BURNOUTS!! lol, sorry, couldn't resist.

lutex- got the confirmation e-mail about your crank bearings, they should be here soon, and i'll get your motor back together and in the bike.

r6buttercup- you ever get all the stuff together so i can get it all taken care of for you?

ray- as soon as i get a moment away from my house, i'll swing by and get that crank seal swapped out for you.

i think i'm forgetting someone....

i have an atv being dropped off in a few for a jet kit.

i need to start writing this stuff down..

anyone else need any work?? c'mon people, i'm on a roll now, lol.