I didn't come on here sayin I was better than anyone else... So you can stop with that arguement... I'm not here to try to brag about myself or any of that... I simply stated the facts... My work can/does speak just fine for me...

Ok so any one can pick up a pipe bend it up and throw it on a car... And anyone can pick up a wrench, turn a bolt and call themselves a mechanic... So?... It takes skill to bend a pipe to fit high and tight... Snug when needs to be.. .Pretty, sealed welds.. And hangers that don't move excessively... All that takes some know-how... But I put that challenge up to anyone who thinks they can just pick up a pipe and do the damn thang... Shoot me a PM and I'll prove you wrong..

And Please Please PLease show me a tahoe... With duals and nothin has been moved... I'd like to see how they are run so I can start doin'em...
But sorry to say I"ve not seen this yet except to one... which they had to relocate the fuel management box or what ever that thing is on the behind the DS rear wheel... And it's the same thing with blazers... So Please if you wanna call my BS.. Prove me wrong...

I fucked up in the first post... But I see yall read to much into shit and still miss the point... I AM THE BEST EXHAUST TECH BIG AL'S (not franchise) HAS TO OFFER... Unless you can get Dave Thomas to do it.. But he don't do much tech work anymore so good luck...

I have no doubt in my workmanship... And My skills will only get better... So fuck you haters that be hatin...

Peaces
Jade BKA Jigabu

 

double post owns me.

 

contradiction what?


as for the Hoe's:


side by side to the over axle point. sharp 85 degree to the drivers side, put a S in it to clear the brake hose and EVAP canister, and angle it out behind the wheel.

or, if they dont want to have the spare (4 door, the 2 door has it in the back if i recall) you can run them out the back.

suburbans are a little different, mainly cause some of the newer ones have a dual gas tank setup. but it is doable, with minimal flow difference between the sides.

 

I need someone to make my true duals on my TA tuck up better who wants to do it?

 

No yall are tryin to make it sound like I said I was better then any tech outta the city or somethin... When I saids stores, my bad i didn't specify... There is no contradiction...

I'll have to look into that on the hoe... I can't picture it right now...

Ritz come by big al's little creek one day...

 

Does big al's do mandrel bends? I need two S shaped pipes from a y-split to the mufflers. Its around 6 to 8 feet of pipe and in 2.5 inch. I also need one hanger welded on and the mufflers I already have to be hung. Anyone got a rough estimate? I just dont feel like cutting and welding all these pieces to make the pipes.
Sorry the pic is so big.

 

Well I took it to gear's location (Independence) and they couldn't touch it because I have no cats, so I doubt you can do anything with it.

But do you work at the one by Ward's Corner? I can only recall 1 Big Al's on Little Creek. I've delivered there a few times. I work for Bap Geon.

 

yea wards corner... If I can get you in at like 5:15... I might beable to pull somethin off.... I'll check it out tomorrow and let you know....

 

brian would have done it but one of the managers was lurking around...fucking gay shit.

 

I've had work done at the Indian River location...cool peeps up there. best exhaust work I've ever had done though was Affordable Muffler? on Diamond Springs? Too bad they went under.