Looking for a machine shop
#1
Thread Starter
Registered Member
Joined: Apr 2006
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
From: Newport News
Looking for a machine shop
i have a 2000 eclipse 4cyl and i need some intercooler piping made so i am looking for a good machine shop. anyone have any ideas or suggestions?
thanks
thanks
#4
Re: Looking for a machine shop
Just buy straight aluminum pipe and get the elbows and connectors from Hampton Rubber. They have the good bolt clamps as well. You might be able to get a exhaust shop to bend the pipe for you if you need to bend it. Either that, or cut it at the angle you want, then take it somewhere to have it welded.
#5
*Looking for a machine shop for another reason*
*Looking for a machine shop for another reason*
I was wondering if anyone has had experiances with machine shops boring out wheels without jacking up the surfaces? I have a set of wheels I need bored out to 71.5mm so they will fit my car. Can anyone point me in the right direction?
I was wondering if anyone has had experiances with machine shops boring out wheels without jacking up the surfaces? I have a set of wheels I need bored out to 71.5mm so they will fit my car. Can anyone point me in the right direction?
#7
Yup, jolly poopbuggy
Joined: Nov 2002
Posts: 15,599
Likes: 0
Received 0 Likes
on
0 Posts
From: Hampton, VA
Re: Looking for a machine shop
Machine shops don't usually make intercooler piping. You want a performance shop and there aren't any in the area I could recommend for what you're looking for at this minute. I'd usually recommend Millenium, but I'm upset with the way they've treated people lately...
Thread
Thread Starter
Forum
Replies
Last Post
mach442
Automotive Discussion
9
10-01-2008 07:14 AM