Keezy

Trans always shifted fine. No grinds, slips, chatter, etc. One day I got in the car and could not go into any gear. Next day worked fine again. Drove fine for couple hundred miles then went to shift on the highway and would not let me in any gear. Replaced bled fluid and replaced master and slave. Still will not go into any gear. Any suggestions of what it might be? I thought throw out bearing but the tranny is not making any noise. If I put the car in gear and then start it the car pulls like it is an automatic and I can not get it out of gear unless I turn the car off.

99blackcivicsi

broken clutch spring, or bolt backed out of flywheel most likely broken clutch though

if you kept pushing it in theres a good change you have bent your clutch fork as well

heres a visual aid for what your looking for



just pulled this out of my car a week ago

execelon

sounds like your clutch has gone to shit, sometimes the springs in your clutch disc will fall out or become very lose. Then becoming stuck between the pressure plate and disc rendering your throwout bearing and slave cylinder useless.. and you stuck in or out of gear..


^ he beat me

Keezy

Thanks for the posts. Guess my weekend plans will now invole dropping the the trans.

Fabrik8

There isn't any need to make two threads about the same thing. I just deleted the other one. Don't make a third.