wiring harness!!!!!!
#1
registeredbeerdrinkr
Thread Starter
Join Date: Nov 2002
Location: Beaufort, SC
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
wiring harness!!!!!!
ok I have a 92-95 block in my 98 ek
and the is a crank flucktuation sensor
that the 95 block does not have my car runs like shit above 4 grand is there a way to bypass the sensor?
or will a 92-95 pig tail remove the sensor from working if I was using a p28???
thanks for any info
and the is a crank flucktuation sensor
that the 95 block does not have my car runs like shit above 4 grand is there a way to bypass the sensor?
or will a 92-95 pig tail remove the sensor from working if I was using a p28???
thanks for any info
#2
corona connessuer
Join Date: Nov 2002
Location: GUAM
Posts: 3,425
Likes: 0
Received 0 Likes
on
0 Posts
well you need to get an adapter harness for the ability to use the p28 ecm. pm fabrik8 he makes them. i have one in my car (98 ex civic) and it works great. the 2nd o2 is removed and the crank sensor is not needed. the p28 is not quite as tempermental as my factory ecm. plus the rev limiter is slightly higher.
plus if you decide to get hondata then youll already have the ecm and harness that you need
plus if you decide to get hondata then youll already have the ecm and harness that you need
Thread
Thread Starter
Forum
Replies
Last Post