1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PARTS
#1
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
moving mon. make offers!..1991 SR20DET hatch s13 greddy, apex-i, eibach, cusco, etc..
I ADVISE ALL INTERESTED TO TAKE THE TIME TO READ THE ENTIRE THREAD. INFORMATION TOWARDS THE BOTTOM MAY BE PERTINENT TO YOURS OR MY SITUATION.
I AM MOVING AWAY FROM THESE PARTS AND THIS SHELL ON WEDNSDAY 5/20, and i really just want them gone, they aren't free, but i will seriously consider ALL offers...low ball me, i want them gone...
I have a 1991 gloss black 240sx shell in good condition and I am selling many if not all parts off of it. All prices are OBO and the parts are located just east of fredericksburg in king george county. If you want the whole shell, call me and we'll talk business.
CASH TALKS, B.S. WALKS. ALWAYS.
Very good condition s14 seats - $250
Stock s13 open differential - $75
17" gunmetal grey mesh wheels with polished lip - $200 for the set of 4 with 3 shitty tires and one good tire, hahah sorry blame the previous owner for that one. SOLD
Like new autometer boost gauge to 30psi - $50 (ultra lite series)
Good condition transmission for RWD SR20DET - $280 (firm)
Some name brand short shifter for the same trans (dont remember the name was on the car when i got it...may be b&m) - $60
Greddy EGT gauges. Black face. No sending unit. Just the gauge and the pigtail attached to it. $30
Eibach sportline lowering springs (not so great condition but TOTALLY usable, just dont put them on stock struts like whoever had my car before me did lol) $100 SOLD
Driveshaft - $75
Stock silvia fuel pump - $35
Apex-i Dual N-1 3" cat-back exhaust. EXCELLENT condition - $400
GONE
No-name 3" test pipe - $50
Stock turbo dump-tube (2x available) - $25
Factory Ignitors - $50 each (2x available)
Ignitor chips (2x available) - $120 each
Factory RWD SR20DET MAF sensor - $130
Fully ported and polished bare-bones head (needs machine work due to incorrect cam bearing cap installation) $100
Stock SR20DET pistons and rods (All pistons are good, the motor spun a bearing, be it rod or crank i have not gotten to yet so all the rods may be fine as well) $35 a peice, piston or rod, $200 takes all of them
Aftermarket upper strut tower bars Front and Rear $65 a peice. $120 for both
Best means of contact is E-mail at XOsilviaSR20@hotmail.com or by phone at 540-207-6650. I am in dire need of the money and all prices other than the tranny are OBO so call me and low ball me if you feel the need but i'm not a noooooooooob and i know what these parts are worth to the right people.
I'm excepting trades for good condition tires that will fit the oem SE s13 alloys (205/45 or 50/15) (195/50/15)
OR tires for my Kosei K-1's (225/45/16) only
LET ME KNOW.
Pictures of EVERYTHING are available upon serious inquiries)
Thanks guys!
I AM MOVING AWAY FROM THESE PARTS AND THIS SHELL ON WEDNSDAY 5/20, and i really just want them gone, they aren't free, but i will seriously consider ALL offers...low ball me, i want them gone...
I have a 1991 gloss black 240sx shell in good condition and I am selling many if not all parts off of it. All prices are OBO and the parts are located just east of fredericksburg in king george county. If you want the whole shell, call me and we'll talk business.
CASH TALKS, B.S. WALKS. ALWAYS.
Very good condition s14 seats - $250
Stock s13 open differential - $75
17" gunmetal grey mesh wheels with polished lip - $200 for the set of 4 with 3 shitty tires and one good tire, hahah sorry blame the previous owner for that one. SOLD
Like new autometer boost gauge to 30psi - $50 (ultra lite series)
Good condition transmission for RWD SR20DET - $280 (firm)
Some name brand short shifter for the same trans (dont remember the name was on the car when i got it...may be b&m) - $60
Greddy EGT gauges. Black face. No sending unit. Just the gauge and the pigtail attached to it. $30
Eibach sportline lowering springs (not so great condition but TOTALLY usable, just dont put them on stock struts like whoever had my car before me did lol) $100 SOLD
Driveshaft - $75
Stock silvia fuel pump - $35
Apex-i Dual N-1 3" cat-back exhaust. EXCELLENT condition - $400
GONE
No-name 3" test pipe - $50
Stock turbo dump-tube (2x available) - $25
Factory Ignitors - $50 each (2x available)
Ignitor chips (2x available) - $120 each
Factory RWD SR20DET MAF sensor - $130
Fully ported and polished bare-bones head (needs machine work due to incorrect cam bearing cap installation) $100
Stock SR20DET pistons and rods (All pistons are good, the motor spun a bearing, be it rod or crank i have not gotten to yet so all the rods may be fine as well) $35 a peice, piston or rod, $200 takes all of them
Aftermarket upper strut tower bars Front and Rear $65 a peice. $120 for both
Best means of contact is E-mail at XOsilviaSR20@hotmail.com or by phone at 540-207-6650. I am in dire need of the money and all prices other than the tranny are OBO so call me and low ball me if you feel the need but i'm not a noooooooooob and i know what these parts are worth to the right people.
I'm excepting trades for good condition tires that will fit the oem SE s13 alloys (205/45 or 50/15) (195/50/15)
OR tires for my Kosei K-1's (225/45/16) only
LET ME KNOW.
Pictures of EVERYTHING are available upon serious inquiries)
Thanks guys!
Last edited by XOsilvia; 05-18-2009 at 07:38 PM.
#2
Registered Member
Join Date: Apr 2005
Location: norfolk,VA
Posts: 346
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
pm
#3
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
bump to the top! who needs sr20 parts??? i know my drifting boys are out there somewhere.
#4
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
TTT dori dori driftooo!
#5
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
ill take those strut bars what brand are they and do you have pay pal. I drift and i'm a boy
#6
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
bump. all prices are o.b.o.....who gots da loot and wants da booty? hahahah
#7
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
Sorry guys, been out a while. hit me up if you want pix...i can get pix of whatever you like.
#8
Boner Jams
Join Date: Feb 2003
Location: Dirty ass kempsville
Posts: 7,227
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
do you have sr hot pipe?
#9
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
pics of shosrt shifter
#10
Registered Member
Thread Starter
Join Date: Jan 2007
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1991 Built SR20DET hatch s13 (greddy, apex-i, eibach, cusco, etc...) TONS OF PART
wheels and springs pending as of tonight...