Need help building 4g63
#1
rotary desu ne!?
Thread Starter
Join Date: Mar 2003
Location: SOVA
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Need help building 4g63
We are building a 50trim powered gst with greddy electronics (e-manage and e-01 programer/boost controller)
have full rebuild kit from machV, hks 264,272 cams, and we need to put the motor together. the only thing is...never done it before. Is there anyone out there that would be kind enough to come over and give us some help? or maybe a website with a guide?
Thanks alot for any help.
have full rebuild kit from machV, hks 264,272 cams, and we need to put the motor together. the only thing is...never done it before. Is there anyone out there that would be kind enough to come over and give us some help? or maybe a website with a guide?
Thanks alot for any help.
#3
RIP Chris Schader
get a chiltons manual, its helpful. ive built 4g63t about 4 times now. i would help you but i dont think i live near you + i am busy building my new AWD car good luck
#4
❒Good ❒ Better ✔Best
Join Date: Nov 2002
Location: Fredericksburg
Posts: 4,598
Likes: 0
Received 0 Likes
on
0 Posts
sounds like a blast... i am making 427whp with that setup.. only using a SAFC instead of e-manage.. i am thinking of swithcing to e-manage.... it is a very nice unit.. the E01 boost controller on the other hand is a POS and very unstable.. i'd save the money and use a mechanical.. any questions.. ask
#5
rotary desu ne!?
Thread Starter
Join Date: Mar 2003
Location: SOVA
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
i've relocated to VA beach. on birdneck. so if anyones close any help or guidance would be great.
..::edit::..
Were using the E01 becuase it can interface with the E-manage. if worst coems to worst a manual one will be used and he e01 for programming
..::edit::..
Were using the E01 becuase it can interface with the E-manage. if worst coems to worst a manual one will be used and he e01 for programming
Thread
Thread Starter
Forum
Replies
Last Post