84 s10 355ci for your 2 door honda or acura
10-19-2010, 09:23 AM
#1
Registered Member
Thread Starter
Join Date: Dec 2006
Location: Natural Bridge
Posts: 533
Likes: 0
Received 0 Likes
on
0 Posts
84 s10 355ci for your 2 door honda or acura
Name: Adam
Location: 20 mins north of Roanoke
Means of contact: PM or this thread.
Price: like to have a 2 door teg.
http://s151.photobucket.com/home/pyscolilboy17/index
Vehicle: 1984 Chevy S10 355ci
Miles: unknown on engine. 149,xxx on body
Engine: 350 bored .30 over with pop top pistons. Eldebrock 850cfm carb. Eldebrock performer rpm intake. Don't know much about the top end just that it has roller rockers.
Exterior: roll pan to replace rear bumper.
Interior: bucket seats to replace the bench seat. Steering wheel is not original, I believe it is out of an older caviler. B&M rachet shifter.
Drivetrain: 700r, stock 10 bolt with spyder gears welded.
Bad: the 700r is shot, I have th350 with a shift kit along with an 8.8 Ford with 4.11 gears I will throw in if the car is right. The rear end will have to be narrowed. It could use a respray. The rear roll pan is new so it doesn't match the truck.
Location: 20 mins north of Roanoke
Means of contact: PM or this thread.
Price: like to have a 2 door teg.
http://s151.photobucket.com/home/pyscolilboy17/index
Vehicle: 1984 Chevy S10 355ci
Miles: unknown on engine. 149,xxx on body
Engine: 350 bored .30 over with pop top pistons. Eldebrock 850cfm carb. Eldebrock performer rpm intake. Don't know much about the top end just that it has roller rockers.
Exterior: roll pan to replace rear bumper.
Interior: bucket seats to replace the bench seat. Steering wheel is not original, I believe it is out of an older caviler. B&M rachet shifter.
Drivetrain: 700r, stock 10 bolt with spyder gears welded.
Bad: the 700r is shot, I have th350 with a shift kit along with an 8.8 Ford with 4.11 gears I will throw in if the car is right. The rear end will have to be narrowed. It could use a respray. The rear roll pan is new so it doesn't match the truck.
Last edited by Pyscolilboy17; 10-19-2010 at 08:24 PM.
