ok here's the scenario i have a EF hatch with a b16a/t , ok so i started the car up the other day after recharging the battery because the kill switch drains the battery (yes i know now to remove the terminal from the battery when the cars off) so it started up perfectly fine idles fine and all so i go to drive it spooled up fine then got to the stoplight down shifted to turn then hit the gas again and felt no reply at all what could be the problem ? i know i need a new wiring harness .

now keep in mind car had no cel lights on before all of this happened now it does have a cel light

i need help asap .

 

well you should go check and see what cel you are throwing and that might help people out when trying to help

 

and how would i be able to check that

 

obd0 b16?

 

obd1

 

Well if your obd1 take it anywhere with a scan tool and they'll tell you.

 

http://check-engine-light-codes.blog...retrieval.html


or reference this.

 

thank you sir that chart is helpful

 

i just don't know much about all this electrical stuff so i'm referring to you guys on here .

 

you felt nothing as in the car died or as in the turbo didnt spool?

because its a little broad...and it could be many things depending on which you are having issues with.

if the car died, check the terminals and make sure they are connected properly, go have the alternator and battery checked and see if either are bad, check the fuel filter for clogs, clean out the pcv valve.

there are plenty of options of things gone wrong.

if the turbo doesnt spool, you can narrow it down considerably...


so, depending on which is the issue.....