Title says all.

I need these to clean up my turndowns I have for my dumps. One of my techs has a mig welder, but doesnt have a plasma cutter for this.

 

i used to have one
You can try minz tire southside, I think they have one....dunno if he will rent it out

 

I might know someone but you'd have to drive over to mechanicsville. I'll ask tonight.

 

Ok thanks. These tips are off the car for now.

 

works wonders...

 

LOL..takes too much effort verse a few seconds

 

But in the time it took you to post this and then stay on top of it waiting for someone to loan you a plasma cutter (not gona happen) you could of already hacksawed your exhaust to your liking. Lazy mofo.

 

Erik on here does, ChasinRacin, he comes and hangs out quite often, he had the green GT, now has the silver 03 cobra. I think he comes home this weekend from school, so ill ask him for you.

 

My plasma cutter is a bench mount design used much like a router top-mount for cutting plate steel. Up in Maryland with the rest of my biggie tools. You're not gonna wanna hold that monster under your car!

Use a sawz-all with a few cheap metal cutting blades from Harbor Freight then clean it up with a 2" angle grinder then perfect it with a Dremel if necessary. On my trailer and on my car's exhaust, I've used 2" cutting discs on an angle grinder. Works great if you mind the gas lines for sparks.

 

The tips are OFF the car. Just another reminder...lol. I am gonna try a cutting wheel tomorrow and see how that works at work.