TONS of DSM parts FS (several partouts)

Closed Thread Subscribe

Thread Tools

08-30-2010, 10:19 AM

Twenty5psi

Registered member

Thread Starter

Join Date: May 2008

Posts: 12,025

Likes: 0

Received 0 Likes on 0 Posts

TONS of DSM parts FS (several partouts)

***EVERYTHING IS SHIPPED UNLESS YOU WANT TO DRIVE TO PA TO PICK IT UP!!!***

I will meet up to a certain distance on major items or bulk buying of up to more than 700 dollars worth of parts. I'm not meeting you 200 miles to pick up a boost gauge

I decided to partout my entire collection of parts I had sitting for my 29k mile gsx and just make the car stock.

Built longBlock:
-6- bolt
-Bored .20 over
-Ross Racing Pistons (8:3 to 1)
-Manley H-Beam Rods
-Acl main and rod bearings
-Balance shaft eliminator kit
-New oem oil pump
-New alternator
-New front and rear main seals
-New oem crank pulley
-New oem tensioner
-Greddy kevlar racing timing belt
-ARP Mains
-OEM Mitsubishi oil filters with Mobil 1 oil
-Full port job done by Norpa machine in Woodbridge, Va
-Complete valve job
-Manley 1mm oversized valves with valve springs and retainers
-New valve stem seals
-Cometic head gasket
-ARP headstuds
-Receipts for motor internals. I drove this setup for 5 hours straight back from VA where I bought the car and it drove perfect. Compression is perfect as well. This entire setup has slightly more than 1k miles on it.
--I will sit on this for months if I get lowball offers unless I need space or something--
-2000
-New Precision SC6165s turbo w/ warranty card
-Custom T3 exhaust manifold (no junk material/ welds here)
-Turbosmart 38 mm "street-gate" external wastegate
-Shearer 2.5" T3 flanged o2 housing (new)
-1000 for everything!!! --THIS IS A STEAL!!!--

-HKS Drager catback exhaust (500 miles)- 300
-Victory Performance FMIC kit w/ greddy type r bov(over 1200 new retail--big boy IC setup!!!)- 500 minus the bov, 600 w/ bov

-Walbro 255 lph. fuel pump- 35
-Fuel Injector Clinic 850 cc Fuel Injectors- 145
Greddy Electronic 60mm boost gauge-125

Greddy electronic 60mm EGT gauge w/ probe- 200

--will sell both and throw in full a-pillar pod for 275
-Eprom ECU with Version 1 DSMLink- 400!!! --STEAL--

-Barely used Sparco Milano black/ grey seats w/ sliders (over 2000 new)-900 (this is less 500 for each seat and sliders for seats that retail for ~2k!!!)
-BAER Pro Big Brake Kit – 4 piston calipers with 13.5” rotors (cross drilled)--monster big boy brakes!!-- 800

-Rays Engineering Gram Lights 57c rims painted black w/ dunlop tires- 800
-Blitz SBC-ID boost controller- 250
-Blitz Power Meter ID- 125

will sell both for 350
-Ground Control Coil-Overs w/ Koni Adjustable Shocks (5k miles)- 450
(small paint bubbling here and there, nothing major)

-Front ebay and rear RRE strut tower bars- 90
-Spal slim fan- 30
-HID's brand new never installed
-autometer a/f ultralite gauge- 15
-Full Infiniti Kappa Perfect Component System Infiniti Kappa Perfect 6x9 3-way speakers- 125

__________________________________________________ ___________________________________

I am parting a 97 GST. All larger items are picked up in 17754, or I can deliver them up to a certain distance for a fee.

Rolling shell w/ 100k miles on it. The car has an authentic Rudora bodykit and is painted Lexus 2004 Lexus "Crystal White". The kit and paint cost more than 3k alone. There is absolutely no rust on the shell and was never in an accident. The rolling shell will not come with motor/ trans. It will include:

18" ADR Kasai's in Black (two have curb rash and some paint fade)
Practically new tires
Thermal 3" exhaust
Apexi GT-Spec Stainless Steel 3” downpipe
VERY sought after black interior minus the seats

Get out of that rust bucket and swap your motor/ trans into a very clean lower mileage shell!!

(pictures are from previous owner, but it looks exactly the same minus the lowering springs--will come with stock suspension)

-1000 (the exhaust and wheels/ tires are worth this alone!!

TRE Racing Transmission with Double Synchro 2nd, 3rd, and 4th gear. Steel shift forks. 5th Gear from an AWD transmission (gives it a longer 5th gear, so it cruises at lower RPM and has top speed of 187mph).
Quaife Limited Slip Differential- (Current price new =$1200)(only about 7k miles on everything) over 3500 in retail- 1600
ACT 2600lb clutch- 190
Fidanza lightened flywheel- 125
18's w/ practically new sumimoto tires- 475

Buscher 20G Turbo (ported and clipped) w/ feed and drain lines/ coolant lines, 2.5" o2 housing w/ tial 40mm wg and dumptube-800 --STEAL--

magnecore plug wires- 30

660cc injectors-125

08-30-2010, 10:20 AM

Twenty5psi

Registered member

Thread Starter

Join Date: May 2008

Posts: 12,025

Likes: 0

Received 0 Likes on 0 Posts

Re: TONS of DSM parts FS (several partouts)

3" Intake pipe w/ GM MAF and MAFT- 180

2g gauge cluster w/ 89k miles--has 10k rpm limit and 200mph limit white overlays (clear cover comes with it--just not pictured) -75

dual gauge pod w/ autometer a/f - 25

98 23 spline t-case with only 29k miles- 100

97 t-case- 75

stock infinty cd player full din- 25

brand new car alarm system in box- 50
2g mas- 25
2g coil pack- 25
misc sensors
stock clutch w/ 29k miles- 30

extremepsi 2.5" 90* elbow w/ 1 t-bolt clamp-20

2g awd 2 piston brakes- 40 /pair

a-pillar 3 gauge pod- 20
2g talon tails- 25
1g head w/ cams- 100

1g head ported slightly and supposedly recently rebuilt (snapped timing belt--bent valves)- 50

2g rad (has a cracked off piece around the top fill tube, but still is good to use) -20
doors with glass and power locks and windows--driver side has broken handle- 40 each or 65 for pair
2gb talon rear bumper- 30
2gb talon wing- 40