Fabrication Guru's needed......
#1
A.P.E.
Thread Starter
Join Date: Nov 2002
Location: NN
Posts: 610
Likes: 0
Received 0 Likes
on
0 Posts
Fabrication Guru's needed......
We purchased a brand new stock replacement steel fuel tank for our 91 RS project car.
and a steel sump kit....
which you can see in this picture.
It appears that the sump is too large for our application.
I need someone to fabricate a smaller / thinner sump and weld it to the tank, too support our Aeromotive A1000 Fuel pump.
thanks
and a steel sump kit....
which you can see in this picture.
It appears that the sump is too large for our application.
I need someone to fabricate a smaller / thinner sump and weld it to the tank, too support our Aeromotive A1000 Fuel pump.
thanks
#9
A.P.E.
Thread Starter
Join Date: Nov 2002
Location: NN
Posts: 610
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by SlidingS-10
shit if i knew thats what you wanted i could have dun that i thought you wanted a hole nother one made
shit if i knew thats what you wanted i could have dun that i thought you wanted a hole nother one made
But, hey....what he wants is what he gets....... its his money......
#10
Mighty Mouse Powered
Join Date: Nov 2002
Location: NN
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
give donnie harris a call, look him up in the phone book under Harris Truck and Body...he's located on industrial park up past denbeigh on jefferson....he runs a truck repair and body shop, but owns a race team and does race and vintage cars on the side.....did all the work to my car.