Cam gear question......
#1
Cam gear question......
I had a d16z6 and bought a cam gear for it.Then decided to use a d16y8 instead and was wondering if they were the same.I know it will fit, but i was told that i had to set it on 4 degrees advanced for the timing to be right on the y8.Any help would be greatly appreciated.thanks in advance
#2
Re: Cam gear question......
just put it on 0, and re do timing on the car to stock. and it shouldn't matter i would think. but i don't mess with to many single anymore so i can't say to be 100% on it.
but i would think if you have the cam gear on 0 and just re do timing on the car to stock spec it would be stock. not advanced or anything. but i get a second opion to safety on it.
but i would think if you have the cam gear on 0 and just re do timing on the car to stock spec it would be stock. not advanced or anything. but i get a second opion to safety on it.
#4
Re: Cam gear question......
but YOU CAN NOT USE A STOCK Y8 CAM GEAR,AND IF YOU DO RUN A AFTERMARKET Y8 CAM GEAR MAKE SURE TO TO ADVANCE THE TIMING 4.75 DEGREE
HERES A PICTURE
Ignore the bottom end caption,thats my motor.
Last edited by madsteez; 04-06-2008 at 05:03 PM.
#5
Re: Cam gear question......
thats what i thought,oh i have a completely stock y8 also.sold the z6 swap but still had the aftermarket cam gear so i was gonna use if i could.thanks alot
Last edited by h23havoc; 04-06-2008 at 04:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post