hey..i need help looking for a shop that can do a b16 head and is respectable..

i also have been recommended to check accurate cylinder heads... could anyone vouch for this shop? thanks

 

Seth at Abacus

 

bring it up to Abacus

 

if you are getting a p&p done.. make sure it's done on a flowbench or you can do more harm than good

 

where exactly is that at, im going to need some work done soon

 

we are at 1372 Baker Road. Virginia Beach, VA 23455.

If you are coming from 64, get off at northampton and go towards the chesapeake bridge tunnel. Go to your 3rd stoplight and make a left. There will be a 7-11 on your left. that stoplight is Baker road. Go down and cross over the railroad tracks and we are the 2nd driveway on the right side.

757-363-8878

-Francisco

 

so abacus is the only shop that does headwork around here? no p&p needed just normal angle job and inspection...

 

I wouldnt say ONLY, i would best quality. we have the most experience, the best tools, and have the desire to work on these heads specifically