MSD SCI wiring diagram
#1
Registered Member
Thread Starter
Join Date: Nov 2002
Location: Va Beach
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
MSD SCI wiring diagram
Just bought a used MSD SCI ignition unit and I'm trying to figure out where the white wire connects to.......... can someone out there give me a little hint??? I would appreciate it . TIA
#2
Former 757'er
Join Date: Nov 2002
Location: Louisville, KY
Posts: 1,214
Likes: 0
Received 0 Likes
on
0 Posts
Re: MSD SCI wiring diagram
Originally posted by g@ttigang
Just bought a used MSD SCI ignition unit and I'm trying to figure out where the white wire connects to.......... can someone out there give me a little hint??? I would appreciate it . TIA
Just bought a used MSD SCI ignition unit and I'm trying to figure out where the white wire connects to.......... can someone out there give me a little hint??? I would appreciate it . TIA
#3
Registered Member
Thread Starter
Join Date: Nov 2002
Location: Va Beach
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
It's going in a 91 rex sohc motor.......... the white wire indicates it should be connected to points or amplifier output (connects to yellow wire of timing accessories) at least thats what it says on the back of the unit. The other is a plug indicating it's a magnetic pickup in distributor or cranktrigger. It states that you have to connect one of them but not both of them at the same time......... any clue on what this means? TIA
#4
Former 757'er
Join Date: Nov 2002
Location: Louisville, KY
Posts: 1,214
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by g@ttigang
It's going in a 91 rex sohc motor.......... the white wire indicates it should be connected to points or amplifier output (connects to yellow wire of timing accessories) at least thats what it says on the back of the unit. The other is a plug indicating it's a magnetic pickup in distributor or cranktrigger. It states that you have to connect one of them but not both of them at the same time......... any clue on what this means? TIA
It's going in a 91 rex sohc motor.......... the white wire indicates it should be connected to points or amplifier output (connects to yellow wire of timing accessories) at least thats what it says on the back of the unit. The other is a plug indicating it's a magnetic pickup in distributor or cranktrigger. It states that you have to connect one of them but not both of them at the same time......... any clue on what this means? TIA
#8
Registered Member
Thread Starter
Join Date: Nov 2002
Location: Va Beach
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
msd
I'm using an MSD Blaster 2 external coil, I'm removing the stock internal coil in the distributor............... You said to connect the negative wire from the factory and connect it to the white wire from the MSD SCI unit? Will try this tomorrow afternoon and will post if successful . TIA G@ttig@ng
#10
Registered Member
Thread Starter
Join Date: Nov 2002
Location: Va Beach
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
MSD
Thanks bro!.......... I was going to do it today but weather sucks.......... I believe your right on that negative wire from the factory coil. Do I cap the postive side of the factory coil wire since the MSD has wires connecting to the external MSD Blaster 2 coil?
G@ttigang
G@ttigang