ok i recently done a b18c r swap in my 93 eg and it fired right up after getting a left hand drive harrness but vtec doesnt work? i even made sure my car was wired up for vtec since its a 93 but it had a b20/vtec in it before so its wired up sooo help please i put new oil in it and i kinda over filled it like a half inch would that be a problem?

 

1st: Wrong section
2nd: google it
3rd: u fuxxed

 

did you check the vtec fluid?

 

.

 

I'm not the smartest guy on all this stuff, but I do know VTEC works off of oil pressure. Might be the VTEC solenoid, could be the ecu-are you sure it's a VTEC ecu? Chipped for VTEC, if not? I'd make sure of those first. Oh, and did you fill it up a half inch too high on the dipstick? If so, I'd pull the plug real quick and drain some off til you're good again. Jus my .02

 

fuck you're VTEC isn't working? YOU'RE DOOOMED!

 

and just in case you didnt know OP the mixture is=50% Cheetah Blood/ 50% unicorn tears

 

^lulz

 

I know what the problem is... you need a replacement VTAK for the rear to mate to the VTEC in the front. Since they run asynchronously, if one fails then the other tries to handle the load, failing catastrophically....

Like this thread.

 

1. Take it to a reputable shop before you fuck something up

2. Failing that, blast it with piss