motor problems
#1
Registered Member
Thread Starter
Join Date: Nov 2002
Location: hoodbridge
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
motor problems
aight guys problem is this. have a 82mm ls/vtec stage 3 cams, the works. 3 days after rebuild the car was started in the morning and ran for approx. 1 min. shut off. figured out the clutch and flywheel had gone out. replaced both. finished tonight and now i will still doing the same thing run for a min and then die. the car has fuel, spark, compression, timing, everything needed. i am lost i have checked all sensor connections, all are fine. also i need to know i have a loud rod/crank knock. could this be contributed by forged products???? let me know any suggestions
#3
Type-R; Tight Car
Join Date: Feb 2003
Location: Seattle, WA
Posts: 3,429
Likes: 0
Received 0 Likes
on
0 Posts
Re: motor problems
A LIGHT knock is totally normal when using forged pistons when the motor is cold. Forged internals expand with heat.
As far as your problem with the motor running for a minute and then shuting off, the only thing I can think of would be the MAP sensor possibly bad thinking it is seeing possitive pressure and telling the ecu to cut the car off (which usually takes a few seconds after sensing poss. pressure).
As far as your problem with the motor running for a minute and then shuting off, the only thing I can think of would be the MAP sensor possibly bad thinking it is seeing possitive pressure and telling the ecu to cut the car off (which usually takes a few seconds after sensing poss. pressure).
Thread
Thread Starter
Forum
Replies
Last Post