Teg springs on EG
braap braap
Joined: Jul 2003
Posts: 14,536
Likes: 0
From: Portsmouth
Re: Teg springs on EG
Originally Posted by Spike101
I am wondering will Tein S Techs for an Teg fit on an EG?
My (old) car was a 95 Civic Ex, with a OBD-1 B16a swap. I had a set of S-Techs from a integra on it and it caused the ass end to sit up a little higher, but it wasn't raked bad. It looked good in fact.
If you would like, I can post a picture. Thats the only concern, that I know about.
braap braap
Joined: Jul 2003
Posts: 14,536
Likes: 0
From: Portsmouth
Re: Teg springs on EG
Ignore the front lip. I hated it on the car, it looks so much better without it...
Its not a bad angle. You coulda put some subs back there, but it's not bad at all. Actually, I found it to look pretty good.
Hopefully that helps. It also had Integra stock struts on it too, that were fairly new.
Its not a bad angle. You coulda put some subs back there, but it's not bad at all. Actually, I found it to look pretty good.
Hopefully that helps. It also had Integra stock struts on it too, that were fairly new.
Justa lil 6
Joined: Jul 2003
Posts: 2,326
Likes: 0
From: VA 757
Re: Teg springs on EG
Originally Posted by Jarrod
Ignore the front lip. I hated it on the car, it looks so much better without it...
Its not a bad angle. You coulda put some subs back there, but it's not bad at all. Actually, I found it to look pretty good.
Hopefully that helps. It also had Integra stock struts on it too, that were fairly new.
Its not a bad angle. You coulda put some subs back there, but it's not bad at all. Actually, I found it to look pretty good.
Hopefully that helps. It also had Integra stock struts on it too, that were fairly new.
whore.
