Ej8Kid

OK as title states i need help removing a crank pulley bolt. Car is a 91 civic dx motor is a d15b. The thing is i have no air tools all i have is my drive way i broke 4 sockets today trying to get it off the bump the motor way. So the real question is... is there anyway i can get the bolt off with out air.. plz help any ideas will be greatly apprecated(sp)

elambz

Don't you live by Fran? Give him a holla, he's got everything.

esohsee

go to pep boys and buy a 17mm impact socket and use a breaker bar with an extension. thats what i used.

Ej8Kid

yea i live by fran if all else fail ill pop up in front of his house like always

Ej8Kid

im gonna try that today thanks for the idea

MGBRaceman

Don't forget PB Blaster, it always helps.

Jay

Don't use a ratchet, use a socket on breaker bar. Crank it over again.

EvolutionBoostin

Take the dust shield off the back of the flywheel and thread a long 12mm bolt into the other side of the clutch bolt holes so the flywheel is braced against the engine block. Next get a good quality breaker bar and a 17mm impact socket and put a piece of steel pipe on the breaker bar. should come loose without too much effort. you'll bend the shit out of the holder bolt, but as long as you use a long enough bolt it won't get sucked up into the motor. I use this trick a few times a week on stubborn crank pulleys and have never ran into one that I can't get like this.

Ej8Kid

that was my last idea i tried it and it worked like a charm

Str8EJ

19mm, no?