00 si problem
#1
Registered Member
Thread Starter
Join Date: Jul 2004
Location: Newport News
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
00 si problem
I m in the middle of swapping a new motor in y car but i cant get the hub nut off. tried a 6' breaker bar and an impact wrench so far but if someone has another suggestion let me know
#2
Banned
Join Date: Oct 2005
Location: Virginia Beach, Virginia fucka
Posts: 3,258
Likes: 0
Received 0 Likes
on
0 Posts
Re: 00 si problem
Hub nut? your talking about the AXLE Nut correct? If so, When mine wouldn't come loose, I had my 300LB friend stand on the breaker bar.
#3
Doin' (today) stuff
Join Date: Nov 2002
Location: Bad News/IOW
Posts: 1,381
Likes: 0
Received 0 Likes
on
0 Posts
Re: 00 si problem
get bigger compressor. impact is just the thing for thoes stubborn nuts. also make sure you have the tabs pulled out of the axel shaft. just need a small flat blade screwdriver to bend it back.
#6
Registered member
Join Date: Dec 2004
Location: RAF Lakenheath, UK
Posts: 1,727
Likes: 0
Received 0 Likes
on
0 Posts
Re: 00 si problem
i just did mine, i had to put my car on the ground and have someone hold the breaks and i put the wrentch on it and and i jumped on it
and on the other one that was on there i had to use a chizzle to cut threw the side of it to release the tention off it
and on the other one that was on there i had to use a chizzle to cut threw the side of it to release the tention off it
Thread
Thread Starter
Forum
Replies
Last Post
TheMx3
Tech Talk
11
02-03-2004 01:18 PM