Saw this on Autoblog, looks pretty fun. It's not without it's downsides, like cost, but it has some interesting possibilities. Geeks unite.
http://www.drewtech.com/products/dashdaq.html

 

That is badass!! Guess i better start saving so i will have enough when it is finally released.

It will replace all my gadgets except the radar detector. If only it had a plug for that

 

That's pretty slick... stack has some new toys out just in time for christmas too...

 

pretty!

 

Cheaper than a set of nexus gauges. I'm interested.

 

It's really too bad that it's basically limited to OBD2 cars.

 

I've been looking into a unit that will show engine parameters/datalogging through a small display that I can mount. I've found a few that I like however they are OBD2 and must use OBD2 protocal (K line) to fuction. Like most here, I can not use OBD2.

Here's a few...

Brockway Engineering (OBD2 only)
http://www.brockwayengineering.com/r920.html

Scan Gauge 2 (OBD2 only)
http://www.scangauge.com/

PCS D100/200 (possible OBD2 only)
http://www.powertraincontrolsolutions.com/

PLX R300/500
http://www.plxdevices.com/prod...s.htm

Zeitronix Zt2
http://www.zeitronix.com

Defi Link Display
http://www.nippon-seiki.co.jp/....html

Doctronic
http://www.doctronic.at/eng/pr...g.htm

Am I'm still looking...

 

wow wow weewow! i like.

very nice looking.

 

what also sucks if you are on full standalone your OBD-II port does nothing and I doubt the gauge would work then

 

Unless you have a standalone ECU that has an OBD2 port, which a few do I think.