Wont Rev past 3000 HELP!!!
#1
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Wont Rev past 3000 HELP!!!
after 2 months of trying and trying i finally got a good LS motor not a blown one and i got it started in my crx but now it wont rev over 3000 i think its the dizzy or mabey the throttle body
#3
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Re: Wont Rev past 3000 HELP!!!
yeah it seems to be you see the throttle body was taken off a running car but it may have got damaged during the swap the dizzy i got from pick and pull and it was a obd1 dizzy
#4
Re: Wont Rev past 3000 HELP!!!
check for codes. make sure all the wire connections to the dizzy are good, and check to see if the internals of the dizzy are tight. if you butt connected the harness to the distributor, you should probably rewire with solder this time
#5
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Re: Wont Rev past 3000 HELP!!!
no there all sodered the only code its throwing is crank angle sensor but it shouldnt make it not rev over 3000 im trying to fix the reving problemthen ill fix the crank angle sensor any other things that can make a car not rev over 3000rpm
#6
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Re: Wont Rev past 3000 HELP!!!
running out of options ive spent 500 on motor and 300 to get it rewired and to start now im left with this it wont rev past 3000 help
#7
Registered Member
Join Date: Apr 2006
Location: Chesapeake
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
Re: Wont Rev past 3000 HELP!!!
it will run in limp mode if it has a bad crank sensor. Actualy suprised it will stay running. But when it runs in limp mode it will not rev past about 3000 rpm. Good luck.