OBD2->OBD1 JUmper
Thread Starter
Fucks wit it
Joined: Mar 2004
Posts: 1,650
Likes: 0
OBD2->OBD1 JUmper
i have an ek hatch cx..... putting a ls/vtec in it.... ls/vtec was in an obd1 car comes with obd1 ecu..... if i get the obd2 to obd1 jumper harness... how will i tap in the wires for vtec...? thanks alot
TurboPipingSystems
Joined: Jul 2003
Posts: 1,483
Likes: 0
From: USDM Land, Va Bch
Re: OBD2->OBD1 JUmper
The easiest to do it is tap it directly from your conversion harness. Otherwise, you will have to add pins on the stock side harness then route the wiring to these:
*VTEC solenoid
*VTEC oil pressure sensor +
*VTEC oil pressure sensor -
If GSR head, run these additional pins/wires:
*Secondary butterfly +
*Secondary butterfly -
If you have an OBD2a (96-98 civic), I have a conversion harness for sale. If you buy it, I'll help you tap the wire. $100......
*VTEC solenoid
*VTEC oil pressure sensor +
*VTEC oil pressure sensor -
If GSR head, run these additional pins/wires:
*Secondary butterfly +
*Secondary butterfly -
If you have an OBD2a (96-98 civic), I have a conversion harness for sale. If you buy it, I'll help you tap the wire. $100......
Thread
Thread Starter
Forum
Replies
Last Post