i have a Ek and im getting ready to put a resistor box to run bigger injectors..i kno for the Eg its got a "dead end" clip on the driver side of the engine bay. Since my car used to be obd2 i kno the dead and clip used to be under the intake manifold. and now that i have a obd1 b16 motor i was wondering where i can find that "dead end" clip?

thanks,
Ivan

 

Did you swap the motor harness too? To me, it is so much easier to tap from the yellow/black wire on each injector clip anyway.....

 

thermal's the man

 

oh aiite thanks guys..

 

+1

 

So just to be sure, all four wires that were going from the ecu go to the red one on the resistor box?