hey everyone, i have a question...i am rebuilding my ls/vtec and i have eagle rods and acl bearings and i am wondering why there is no hole in the rods where the bearings go?? because my old motor had stock rods and bearings and there was a little hole for oil in both of them.

 

Eagle rods for imports, hrm. Go have them checked at your local machinist to ensure you didn't get ones that are slightly out of spec before you start the build. 9 times out of 10 when someone spins a rod bearing when using Eagle's, its due to their insufficient checking of their rods (on Eagles part) unfortunately.

Manley/Pauter is the way I would go, personally.

 

... i looked it up and icant find any info. all i ca tell is that all eagle rods dont have holes in them.