need new springs for the integra. looking at around 1.5 inch drop but a comfy ride. whats gonna give me both of these the best? also im running kyb gr2's?

 

skunk2 for height, but a lil bouncy, tein is 2.5 in front and 1.7 in rear but very stiff

 

Tanabe, they make several springs for different uses, check them out.

 

sweet i checked out the tanabe. i like the NF210 and will go with them if i can find some for a 91 integra. will ones for a 94+ integra fit on gr2's?

 

H&R makes a spring for that drop and a good ride too.

 

Sprint Springs! Hands down, they ride awesome and they have different rides heights u can order. Ill be ditching my skunk2 coilovers and getting sprints.

 

on my old da9 i had the tein s-tech springs they were comfortable for the most part but if i had to do it all over again i would have went with the h-tech. the s-tech come with a really aggressive drop in my opinion, but like i always say it your decision just remember to change shocks. your older ones will not be able to maintain after you lower it.

 

You can use stock shocks if the new springs are close to the same spring rate as stock. Cushy drop springs are often about the same spring rate as stock.
GR2s should handle whatever you throw at them though, and are good stuff.

 

i have a set of eibach sportlines on mine and they give a decent drop and a decent ride.

 

if your only looking for 1.5 drop almost any lowering spring will do...
but if it were me, i'd ditch the gr2's and start fresh with ground control coilovers and koni yellows...
and then dump that bitch...haha
good luck with whatever setup you run