installed skunk2 throttle body and now my car wont idle right and it seems like its dumping fuel? how does this happen off a throttle body install? any help is greatly appreciated.

 

check the values of your tps sensor. check the tb if its sticking open or if it's not slightly open.

 

no stick. how do i check the tps ? if i loosen the tps and move it back and forth it really doesnt get any better or worse. if you give it a little gas it still studders until like 2k rpms or so. i really just dont understand this

 

did you put the map sensor back on, and the lil o ring that goes around the hole

 

yes everything is intact, and worked fine before i swapped throttle bodies


ps.im using dorkos name.

 

what mm is the throttle body, and what engine/ modifications are you running.

 

im not sure on the mm cause i just bought it off a friend. its big i know that. jdm gsr. just slight mods nothing big

 

use a multimeter and go off the red wire on the tps with the positive on the multimeter and the neg side of the multimeter on a body ground and turn the tps till the multimeter is at .45 volts that shuld fix ur problem......pm me if u need more details

 

you have the map and tps plugs switched.

 

nah im not that dumb. it was an idea though and i did double check but there correct.