FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
#1
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
Year:1993
Make:Honda
Model: Civic
Trim: CX
ACCEPTING TRADES PLUS CASH
The story to the car is, I purchased it from its original owner about 2 months ago. She had the car in durham NC all its life and garage kept it. Since Ive owned the car its always been garaged also. Very Clean car No DENTS AT ALL. These are the straightest panels you will ever find. Clean paint and immaculant interior as well. Full Back interior including mint floormats. Now to the mods.
Me and a couple of my close friends have Performed every Mod to the car so I can assure you no corners were cut and everything was done right.
Exterior: All mods have less than 500 miles
-Brand new BuddyClub P1 wheels
-New Kuhmo tires
-Oem Style Foglights
-No Dents or Dings No rust cleanest body ive ever seen I would rate it a 9 out of ten
Interior:
-05 Acura Type S seats Black Leather
-95 Acura GSR Gauge Cluster
-Razo Shift Knob
-Skunk 2 Short Throw with New Bushings and New bushings on Linkage
for that firm feel.
-No Name CD player that was Previously Installed
- No Cig burns rips or tears at all the interior is a 9.8 out of 10
Suspension:
-D2 Coilover Kit Purchased New as well less than 500 miles on them
-Omni Power LCA's Less than 500 miles on them as well
-Password Three point upper strut bar
-Skunk 2 rear upper strut bar (not installed)
-C pillar bar (not installed)
-GSR Front and Rear Brake Conversion
-Drilled and Slotted Rotors
-Hawk Pads
Engine Management:
-Chipped and Tuned P73 with S200 Hondata
Engine: Block.
- B18C1 Block Bored .20 over
- JE 12.5.1 Pistons
- Carillo Rods with ARP rod bolts
- Block guard
- Cometic head gasket
- Balanced and blue printed crank
- New ACL race bearings all around
- Unorthodox Light wieght Crank and Alternator Pullys
- Rage Header
- Mandrell bent one peice piping to a stealthy flat black Vibrant Muffler
2.5in all the way back
- Hasport Billet extremely Stiff mounts
- Fluidyne Radiator
- Slimline Fan
- Samco Radiator Hoses
- Moroso Oilpan
Engine: Head
-ENDYN P&P PR3 b16 Head
-3 Angle Valve Job
-Skunk2 valves/springs/retainers/valve seals
-Skunk2 Stage II cams
-Skunk2 Intake manifold port matched to the head and to the 68mm Skunk2 Throttle Body
-RC 370cc Injectors
-BDL Fuel Rail
-BDL Oil seal
-Skunk2 Cam gears
-Type R Valve Cover
-NGK blue wires
-NGK iradium plugs
-AEM Type R Cold Air Intake
-MSD Blaster coil with distributor
-Spoon Oil Cap
-Type R Throttle Cable
-Walbro 190 Fuel pump
-New Honda Oil Pump with Toda Gear
-Greddy Timing Belt
Tranny:
-GSR Y80 Tranny with Type R Diff and LSD
-Excedy 6 Puck Unsprung Race Clutch
-Fidanza light weight Flywheel
The Motor was broken with striaght 30 weight and ever since has only seen royal purple 5w 30 and also used the royal purple tranny fluid. The brakes and been flushed and have new fresh fluid and same with coolant. The car runs great but I have some bills i have to get paid so i have to get rid of some of the toys. The car has no issues other than the oil pan has a plug i guess i you wanted to hook up a line for a turbo setup (it came that way from moroso) and it leaks and little i just dont have a bigg enough alan key to fit it. and because the Greddy belt is a little tighter than factory it makes the cam gears a lil noisy. But im just picky.
The Engine bay has been resprayed a Green with gold pearl. I resprayed it before I put the swap in but the rest of the car is factory white, i planned on repainting the whole car this green but ive run into some finacial issues that i need to take care of.
NEW PRICE: $7200 cash as it sits
OR $6000 you bring your wheels, seats, and no strut bar
Forgot to mention it has a clean title and heres some pics And its got a JDM_Kid wire tuck and a new battery
Make:Honda
Model: Civic
Trim: CX
ACCEPTING TRADES PLUS CASH
The story to the car is, I purchased it from its original owner about 2 months ago. She had the car in durham NC all its life and garage kept it. Since Ive owned the car its always been garaged also. Very Clean car No DENTS AT ALL. These are the straightest panels you will ever find. Clean paint and immaculant interior as well. Full Back interior including mint floormats. Now to the mods.
Me and a couple of my close friends have Performed every Mod to the car so I can assure you no corners were cut and everything was done right.
Exterior: All mods have less than 500 miles
-Brand new BuddyClub P1 wheels
-New Kuhmo tires
-Oem Style Foglights
-No Dents or Dings No rust cleanest body ive ever seen I would rate it a 9 out of ten
Interior:
-05 Acura Type S seats Black Leather
-95 Acura GSR Gauge Cluster
-Razo Shift Knob
-Skunk 2 Short Throw with New Bushings and New bushings on Linkage
for that firm feel.
-No Name CD player that was Previously Installed
- No Cig burns rips or tears at all the interior is a 9.8 out of 10
Suspension:
-D2 Coilover Kit Purchased New as well less than 500 miles on them
-Omni Power LCA's Less than 500 miles on them as well
-Password Three point upper strut bar
-Skunk 2 rear upper strut bar (not installed)
-C pillar bar (not installed)
-GSR Front and Rear Brake Conversion
-Drilled and Slotted Rotors
-Hawk Pads
Engine Management:
-Chipped and Tuned P73 with S200 Hondata
Engine: Block.
- B18C1 Block Bored .20 over
- JE 12.5.1 Pistons
- Carillo Rods with ARP rod bolts
- Block guard
- Cometic head gasket
- Balanced and blue printed crank
- New ACL race bearings all around
- Unorthodox Light wieght Crank and Alternator Pullys
- Rage Header
- Mandrell bent one peice piping to a stealthy flat black Vibrant Muffler
2.5in all the way back
- Hasport Billet extremely Stiff mounts
- Fluidyne Radiator
- Slimline Fan
- Samco Radiator Hoses
- Moroso Oilpan
Engine: Head
-ENDYN P&P PR3 b16 Head
-3 Angle Valve Job
-Skunk2 valves/springs/retainers/valve seals
-Skunk2 Stage II cams
-Skunk2 Intake manifold port matched to the head and to the 68mm Skunk2 Throttle Body
-RC 370cc Injectors
-BDL Fuel Rail
-BDL Oil seal
-Skunk2 Cam gears
-Type R Valve Cover
-NGK blue wires
-NGK iradium plugs
-AEM Type R Cold Air Intake
-MSD Blaster coil with distributor
-Spoon Oil Cap
-Type R Throttle Cable
-Walbro 190 Fuel pump
-New Honda Oil Pump with Toda Gear
-Greddy Timing Belt
Tranny:
-GSR Y80 Tranny with Type R Diff and LSD
-Excedy 6 Puck Unsprung Race Clutch
-Fidanza light weight Flywheel
The Motor was broken with striaght 30 weight and ever since has only seen royal purple 5w 30 and also used the royal purple tranny fluid. The brakes and been flushed and have new fresh fluid and same with coolant. The car runs great but I have some bills i have to get paid so i have to get rid of some of the toys. The car has no issues other than the oil pan has a plug i guess i you wanted to hook up a line for a turbo setup (it came that way from moroso) and it leaks and little i just dont have a bigg enough alan key to fit it. and because the Greddy belt is a little tighter than factory it makes the cam gears a lil noisy. But im just picky.
The Engine bay has been resprayed a Green with gold pearl. I resprayed it before I put the swap in but the rest of the car is factory white, i planned on repainting the whole car this green but ive run into some finacial issues that i need to take care of.
NEW PRICE: $7200 cash as it sits
OR $6000 you bring your wheels, seats, and no strut bar
Forgot to mention it has a clean title and heres some pics And its got a JDM_Kid wire tuck and a new battery
Last edited by mugencivic94; 09-27-2007 at 05:20 PM. Reason: price change
#2
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
#3
got some fake hp
Join Date: Aug 2006
Location: suffolk/ cheasapeake/ptown
Posts: 403
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
what did the setup make number wise?hp
#4
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
on a conservative tune before the better exhuast and before the cam gears it made 202 whp and 140 torque with the new exhuast and the ablility to tune it a lil more with the cam gears i would say another 10whp easy
#5
got some fake hp
Join Date: Aug 2006
Location: suffolk/ cheasapeake/ptown
Posts: 403
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
who did the tuning?
#6
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
Turbo Tune in Greensboro NC , hes pretty good but i know if i can ever get an appointment booked at RLZ howard can def. get some more power out of it
#7
Double Agent HT
Join Date: Nov 2004
Location: Installing Your Theater
Posts: 5,518
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
very nice. I would def trade you for that.
#8
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
illegal.... what do you have send some pics and info
#9
Double Agent HT
Join Date: Nov 2004
Location: Installing Your Theater
Posts: 5,518
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
#10
Registered Member
Thread Starter
Join Date: Jul 2007
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: Balling Eg Hatch , Built GSR, Hondata, Brake upgrade, Buddyclub, skunk 2
ill keep it in ming ill get back to you nice ride tho