ok i have a question about my car its a 93 integra motor with a 90 wiring harness use to run just fine but i wanted to build the motor and now that i have all that done and put it back in the car it sat for about three months im not getting any fuel pressure so i replaced the fuel pump and the main relay and im still not getting any fuel pressure so i dont know wht else it could be so i turned to here thinking some one else might know i could really use the help and thanks for any information that yall give me

 

have you checked if your getting power to the fuel pump ? get back there with a test light and check it, make sure its recieving voltage, check all fuses as well cause honda loves to intertwine there fuses.... if your not getting power trace it from there. need to check your fuel line as well, could be leaking or kinked somewhere, where are you checking for fuel pressure at ? did you use a guage ?. is the fuel pump priming when you cut the ignition to accessory two ?

 

well i have voltage to the fuel pump im checking it near the sending unit and i checked all the fuses

 

is the pump priming when you put the ignition to accessory two or not ?.if your saying its getting power, and its not priming, something is wrong with the fuel pump or the connector to the pump. and you didnt answer, did you check the fuel pressure with a guage ?. and where did you check it if you did ?.

 

i just took the line off at the fuel filter in the engine bay and nothing came out and i dont here it priming and the fuel pump is brand new from napa and the nintey percent of the time have good parts so yea

 

If you have voltage you need to see if you have a solid ground. No ground = incomplete circuit. If you get continuity on your ground with low resistance at the fuel pump connector then the pump is not good.

 

anyone live near suffolk that could come look at it