Hey everyone i was just wondering if yall can help me and tell me what i would need to swap a b18c5 obd2 motor in a EG shell...i have more than enough tools and time and some money saved up for parts although i have more knowledge in motorcycles than cars but ive done stock motor swaps back in the day in autotech in highschool....but yea i would realy appriciate it if someone can list a part sheet of what i would need to buy...thank you...

 

obd2 to obd1 conversion harness, b series mounts, b series shift linkage, b series axles

 

clutch kit-make sure its for a hydraulic/hydro, not cable
flywheel-any B-series
header
ecu OBD1
wiring harness
(tune up parts-spark plugs,wires,dist cap,rotor,oil,oil filter)
Good Ideas(water pump,timing belt,oil pump)
proper OBD injectors,distributor,alternator,starter.

 

It also depends what model eg you are running, vx,cx,dx,si because wiring will be different. Also with what type of engine management you are going to be running toward the future. Even if your tiring to run A/C if any thing(I have a bunch of extra parts laying around if you need any thing). If you need help or need some one to do the swap for you hit me up.

 

www.honda-tech.com

 

+1