FS/FT single cam vtec ZC swap and turbo kit parts
#1
FS/FT single cam vtec ZC swap and turbo kit parts
the swap is a single came ZC, tranny shifts good. Leaks oil ... would be a great motor if you can figure out why the oil pan won't mate to the block correctly.
$550 obo for the swap
$2000 obo for a quality the d series turbo kit
cast iron drag exhaust manifold - like new
Tial 38mm waste gate - like new
Precision intercooler
T3/T4 Borg Warner Turbo with stainless housing (.60 trim I believe - good for 500 HP)~ 500 miles/3 months old - had a rebuild after 100 miles because it was starved of oil because of the oil leak. Rebuilt to new. No shaft play AT ALL.
Nockoff greddy BOV
all charge piping complete
Greddy Profec 2 spec B boost controller - new
2.5" custom mandrel bent down pipe with o2 sensor bung - like new
Will trade for a nice B swap ... no bullshit ...
All work was done by Dan Driskill.
$550 obo for the swap
$2000 obo for a quality the d series turbo kit
cast iron drag exhaust manifold - like new
Tial 38mm waste gate - like new
Precision intercooler
T3/T4 Borg Warner Turbo with stainless housing (.60 trim I believe - good for 500 HP)~ 500 miles/3 months old - had a rebuild after 100 miles because it was starved of oil because of the oil leak. Rebuilt to new. No shaft play AT ALL.
Nockoff greddy BOV
all charge piping complete
Greddy Profec 2 spec B boost controller - new
2.5" custom mandrel bent down pipe with o2 sensor bung - like new
Will trade for a nice B swap ... no bullshit ...
All work was done by Dan Driskill.
Last edited by RA052224; 02-13-2008 at 07:18 AM.
#3
Registered member
Join Date: Oct 2005
Location: Richmond, va
Posts: 3,269
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS/FT single cam vtec ZC swap and turbo kit parts
part out turbo kit?