F/S 89 Civic Hatch Shell
Thread Starter
Registered member
Joined: Feb 2007
Posts: 702
Likes: 0
F/S 89 Civic Hatch Shell
Shawn
Charlottesville
(434)465-5245
$400 OBO
I'm selling my original project hatchback, it's a 89 honda civic dx........
B-SERIES READY!!!
---- COMPLETE MULTI POINT WIRING, inside and out
(only 1 plug was missing from internal harness, as shown in pic, has been wired up properly and ran my b20 vtec just fine in the hatch... NOTICE THE ECU WIRING ISN'T A TYPICAL RAT'S NEST!!!)
---- LS Spindels
---- Flowmaster 2.5" straight pipe exhaust with 40 series muffler
---- Clean CRX SI Seats (driver seat is missing a piece of the foam and was torn, it has been stitched back together, and doesn't seem to draw much attention)
---- Battery relocated to trunk
---- NEW Master cylinder, and front passenger and driver tie rods
---- CRX dashboard, Black rear panels still in car, have rest of a set of FRESH black crx interior that i was going to put in, never got to it
---- front bumper, fenders and small piece underlying the hood, yet above the bumper, came from a 90 hatchback, in GREAT SHAPE... tried those instead of the bondo'd up pieces i had on at the time...
---- car is pretty much a rolling chassis, JUST NEEDS A NICE B SERIES SWAP, have radiator, gauge cluster housing, and the minor things missing from the few pics EXCEPT center console (the climate control area), E-brake cover and the actual heater-core i think
pm or call anytime after 1:30 pm
thanks
NOW PARTING OUT!!! PM ME WHAT YOU NEED!!!
Charlottesville
(434)465-5245
$400 OBO
I'm selling my original project hatchback, it's a 89 honda civic dx........
B-SERIES READY!!!
---- COMPLETE MULTI POINT WIRING, inside and out
(only 1 plug was missing from internal harness, as shown in pic, has been wired up properly and ran my b20 vtec just fine in the hatch... NOTICE THE ECU WIRING ISN'T A TYPICAL RAT'S NEST!!!)
---- LS Spindels
---- Flowmaster 2.5" straight pipe exhaust with 40 series muffler
---- Clean CRX SI Seats (driver seat is missing a piece of the foam and was torn, it has been stitched back together, and doesn't seem to draw much attention)
---- Battery relocated to trunk
---- NEW Master cylinder, and front passenger and driver tie rods
---- CRX dashboard, Black rear panels still in car, have rest of a set of FRESH black crx interior that i was going to put in, never got to it
---- front bumper, fenders and small piece underlying the hood, yet above the bumper, came from a 90 hatchback, in GREAT SHAPE... tried those instead of the bondo'd up pieces i had on at the time...
---- car is pretty much a rolling chassis, JUST NEEDS A NICE B SERIES SWAP, have radiator, gauge cluster housing, and the minor things missing from the few pics EXCEPT center console (the climate control area), E-brake cover and the actual heater-core i think
pm or call anytime after 1:30 pm
thanks
NOW PARTING OUT!!! PM ME WHAT YOU NEED!!!
Last edited by dustyb20; May 15, 2008 at 06:11 PM. Reason: SOME CHANGES!
Thread Starter
Registered member
Joined: Feb 2007
Posts: 702
Likes: 0
Re: F/S 89 Civic Hatch Shell
ONE LAST THING, CAR MUST BE GONE BY THURSDAY, IF NOT I'LL BE STRIPPING IT AND SCRAPPING... FUCKIN NOSEY ASS NEIGHBORS KEEP CALLING THE LAW ON ME, HAVE TO CLEAN UP SOME OF MY STUFF!
HURRY!
HURRY!
Last edited by dustyb20; Mar 21, 2008 at 11:48 AM.
