wtt: 1990 crx si b16a SIR II OBD1
1990 crx si black but primered black because I was going to get it painted.
-obd1 JDM SIR II b16a 55k
-SUPER CLEAN cable b16 trans smooth no grinds at all!
-avid polished motor mounts
-Rywire obd0-obd1 conversion
-hasport shift linkage
-wire tuck fuse box located in side
- Full thermal research development exhaust system
-ebay headers
-crx floor mats custom
-power windows
-battery relocated to the rear
-rear disc conversion
-earl's stainless steel brake lines all the way around
-eibach sportline ground control coilovers
-stock struts (I would put better struts but nessary.
The bad:
-needs paint
-passenger side fender (its a little weak...
-bring your own rims
-needs corner lights
Looking for eg hatches,ek hatchs
Stock is fine
Let me know
The car is pretty quick for a b16
Located in silver spring,md
-obd1 JDM SIR II b16a 55k
-SUPER CLEAN cable b16 trans smooth no grinds at all!
-avid polished motor mounts
-Rywire obd0-obd1 conversion
-hasport shift linkage
-wire tuck fuse box located in side
- Full thermal research development exhaust system
-ebay headers
-crx floor mats custom
-power windows
-battery relocated to the rear
-rear disc conversion
-earl's stainless steel brake lines all the way around
-eibach sportline ground control coilovers
-stock struts (I would put better struts but nessary.
The bad:
-needs paint
-passenger side fender (its a little weak...
-bring your own rims
-needs corner lights
Looking for eg hatches,ek hatchs
Stock is fine
Let me know
The car is pretty quick for a b16
Located in silver spring,md
Thread
Thread Starter
Forum
Replies
Last Post
crxtyper
Parts ARCHIVE
2
Jun 10, 2008 10:06 PM






