Built Turbo LS/Vtec LSD trans
I need to sell this set-up asap...
Was trying to sell all of this stuff separate, but I need it to move. So now I will try and sell it as a full swap.... $3500 obo for a little more I can throw in a competition twin disc used for less then a month....
B18 Block...
2.0
Darton Sleves
Micropolished and Balanced Knife Edged LS Crank
C.P. 9:5:1 pistons
Eagle Rods
ACL Bearings
Type-R Water & Oil Pump
B16A2 Head....
3 Angle Valve Job
InlinePRO Valves
InlinePRO Springs & Retainers
Type-R Cams
InlinePRO Cam Gears
JDM GSR Transmission with Quaife LSD
Fully built by inlinePRO.
Idead on power - 16psi 67trim turbo she was putting a daily driven 433whp



Located in NOVA
Also have a 3inch EK exhaustand the clutch for sale
Please don't offer any trades... I do not own a Honda anymore... I am however interested in SR motors if that applies to anyone.
Make an offer for any of the 3 parts of the engine for whatever, I can only say no or yes
Was trying to sell all of this stuff separate, but I need it to move. So now I will try and sell it as a full swap.... $3500 obo for a little more I can throw in a competition twin disc used for less then a month....
B18 Block...
2.0
Darton Sleves
Micropolished and Balanced Knife Edged LS Crank
C.P. 9:5:1 pistons
Eagle Rods
ACL Bearings
Type-R Water & Oil Pump
B16A2 Head....
3 Angle Valve Job
InlinePRO Valves
InlinePRO Springs & Retainers
Type-R Cams
InlinePRO Cam Gears
JDM GSR Transmission with Quaife LSD
Fully built by inlinePRO.
Idead on power - 16psi 67trim turbo she was putting a daily driven 433whp



Located in NOVA
Also have a 3inch EK exhaustand the clutch for sale
Please don't offer any trades... I do not own a Honda anymore... I am however interested in SR motors if that applies to anyone.
Make an offer for any of the 3 parts of the engine for whatever, I can only say no or yes
Last edited by simplsi; Aug 4, 2008 at 09:05 AM.
Thread
Thread Starter
Forum
Replies
Last Post
gotboosthatch
Import - ASIA
27
Dec 18, 2008 03:55 PM
tarron.shelton
Import - ASIA
26
Sep 30, 2008 07:47 AM
spnamnt
Parts ARCHIVE
26
Aug 27, 2007 09:43 PM






