I have zero experience doing this so I was hoping to get some ideas on who to talk to about getting it done and is there a better alternative to stock for a basic daily driver including better price etc... Thanks for any suggestions!!!!!!!!!!!!!!! Oh yeah, I'm assuming it's best to replace the clutch,pressure plate and throw out bearing???? BTW, the car has about 112k on it so I hope this info helps! thanks again!!

 

if you just get a clutch, you'll get a new throwout bearing with it. It would be best to replace everything while yer in there.

Talk to Chahonda

 

have fun chief........ ill give you a tip though, get someone to help you guide the tranny back onto the dowel pins, i did mine by myself, and its a pain in the ass.........its truthfully not that hard of a process, its just time consuming, and you have to take alot of shit off, like i said, have fun.............and if you order a new clutch from an aftermarket company you should get a new pilot bearing, throwout bearing, clutch alignment tool and pressure plate with the clutch plate........AND MAKE SURE TO GREASE THE HELL OUT OF THE THROWOUT BEARING, AND THROWOUT FORK.....and resurface the flywheel.......75 ft lbs for the flywheels bolts, and 25 ft lbs for the clutch bolts....call me or chahonda if you want to pay to get it done.........

 

i can personally vouch for MORE IMPATIENT's clutch work

 

damn travis, give me a call man....you know ill give you a hand!!

 

have you priced any clutches yet???

i may know of a few good, reasonably priced clutches

 

I can vouch for Chahonda, he did mine about 2 years ago..

 

damn....has it been that long?????